Course 2: Injection Moulding Technology Intermediate

For

Parts designer, mould designer, mould maker, machine operators, plastic moulder, quality assurance personnel, production planner, shift supervisor, purchasing and sales personnel

 

Requirement

 

Course 1 Injection Moulding Technology Basic

 

Contents

Technical thermoplastics • additives • high performance plasticising units • material and colour change • plasticising with barrier and mixing screw • use of mixing screw tip and mixing nozzle • calculation for clamping force • centralised material preparation and conveying • colour and additive mixing • introduction to various automation solutions • recycling • shearing • determine the holding time • determine the injection rate • pvT diagram • influence on shrinkage • mould transfer • hot runner system • mould and hot runner maintenance • types of gates • gate balance • venting • demoulding • dual component mould • in mould decoration

 

Target

 

 

The participants will obtain knowledge about the entire injection moulding process.

 

 

Duration

 

2 days

 

Course Fee

 

USD 880 per participant excluding local taxes

 

Training Locations

Germany  Austria  Switzerland Estonia  Latvia  Lithuania  Russia 
China Taiwan Singapore Vietnam Indonesia Malaysia Philippines

Registration

 

Registration

To register for Course 2,  please use the
above registration form. 

Alternatively you can download the below
PDF registration form, either send by fax
or email the completed form back to us.

 

Registration form (PDF, 110 KB)

zu den schulungsorten