Course 2: Injection Moulding Technology Intermediate


Parts designer, mould designer, mould maker, machine operators, plastic moulder, quality assurance personnel, production planner, shift supervisor, purchasing and sales personnel




Course 1 Injection Moulding Technology Basic



Technical thermoplastics • additives • high performance plasticising units • material and colour change • plasticising with barrier and mixing screw • use of mixing screw tip and mixing nozzle • calculation for clamping force • centralised material preparation and conveying • colour and additive mixing • introduction to various automation solutions • recycling • shearing • determine the holding time • determine the injection rate • pvT diagram • influence on shrinkage • mould transfer • hot runner system • mould and hot runner maintenance • types of gates • gate balance • venting • demoulding • dual component mould • in mould decoration





The participants will obtain knowledge about the entire injection moulding process.





2 days


Course Fee


€640 per participant excluding local taxes


Training Locations

Germany  Austria  Switzerland Estonia  Latvia  Lithuania  Russia 
China Taiwan Malaysia Philippines Vietnam Indonesia Singapore




To register for Course 2,  please use the
above registration form. 

Alternatively you can download the below
PDF registration form, either send by fax
or email the completed form back to us.


Registration form (PDF, 110 KB)

zu den schulungsorten